Register your product and get support atwww.philips.com/welcomeSWW1810EN User manual 3
105 Extend and stick the IR sensor extender cable onto the front side of your HDTV.Note •The IR blaster support 47KHz remote signal protocol, while t
11EnglishOn screen display on HDTVOn screen displayMode and status Standby mode: it is a power-saving mode ... Start up in progress: It takes 15-20
12Select the source on the transmitterPress the source buttons on the remote control, transmitter or receiver until you see the available video from y
13English5 Hook the key holes at the back of the receiver on the screws. 6 Mount your receiverYou can either mount the receiver on the wall or on t
146 Align the adhesive tape on the receiver with the one on the HDTV until both the receiver and HDTV are mounted together rmly.Note •The use of adh
15EnglishPower supply:Input: AC 100~ 240VOutput: DC 5V, 2A Operating temperature:0~40°C/32~104°FTransmitter interfacesA/V interfacesHDMI input: Two (T
16IMPORTANT NOTE:Radiation Exposure Statement:• This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
17Englishnegative consequences on the environment and human health.Please visit www.recycle.philips.com for additional information on a recycling cent
189 Frequently asked questionThe power LED on the receiver is not lit up in red in standby mode. • Make sure that there is power supply for the trans
19EnglishIf the picture quality is poor, what do I do? • Make sure that the video resolution of your source device matches the resolution of your HDTV
20 EN
21
© 2011 Koninklijke Philips Electronics N.V.All rights reserved.IFU_SWW1810_EN_V2.0WK11485
3EnglishContents1 Important 4Safety 42 Your Wireless HD AV Connect 6What is in the box 63 Overview 7The transmitter 7The receiver
4e Do not use this apparatus near water.f Clean only with dry cloth.g Do not block any ventilation openings. Install in accordance with the manufac
5Englishn Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supp
6 HDMI cable IR blaster extender cable Power adapter for the transmitter and receiver x 2 IR sensor extender cable Anchors x 2 Screws x 2 Quick
7EnglishThe receiverTop view 1 Source LEDs Indicators for HDMI1 and HDMI22 Power button with the LED indicatorPress to turn the receiver on/off.3 Sour
8The remote control 1 POWER buttonPress to turn the transmitter and receiver on/off.2 INFO buttonDisplays on the HDTV the connection status of the rec
9English2 Connect the supplied power adapter to the transmitter.• Connect one end of the power adapter to the DC IN jack of the transmitter. • Conn
Commenti su questo manuale