Philips SCD590 Manuale Utente

DECT Baby MonitorSCD590

Battery operationThe parent unit runs on two rechargeable 1.2V AAA NiMH batteries that are supplied with the appliance. Make sure your hands and the u

The LINK light ashes red briey and then starts to ash green while the parent unit tries to establish connection with the baby unit.The LINK light o

2 Briey press the volume + and – buttons on the parent unit until the desired microphone sensitivity level for the baby unit has been reached.Note:

Connecting the belt clip 1 Insert the small pin on the back of the belt clip into the opening on the back of the parent unit (1). Turn the belt clip

Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and

Frequently asked questionsThis chapter lists the questions most frequently asked about the appliance. If you cannot nd the answer to your question, c

Question AnswerWhy does the parent unit react slowly to the baby’s crying?The microphone sensitivity level of the baby unit may be set too low. Increa

Question AnswerThe microphone sensitivity level of the baby unit may be set too high, which causes the parent unit to consume a lot of energy. Decreas

182 3 4 56 7 8 910 11 12 131415 16 1718192021

1922 23 24 2526 27 28

2

4222.002.6467.2

315491012231234156756 7 8 911101113121314161781

4

SCD590ENGLISH 6

6IntroductionPhilips Avent is dedicated to producing caring, reliable products that give parents the reassurance they need. This Philips Avent baby mo

15 Do not place this product on an unstable cart, stand or table.The product may fall and sustain serious damage.16 Make sure the baby unit and the

Compliance informationThe FCC ID number is located on the casing bottom of the parent unit and in the battery compartment of the baby unit.The term ‘I

10 Small plug 11 Battery compartment lid12 Inlet for small plug13 Battery compartmentB Parent unit (2 pieces, only one is shown)1 TALK button 2